tag:blogger.com,1999:blog-4229172837911249933.post8300963468527497306..comments2024-01-23T13:10:25.332-05:00Comments on Nails and Sawdust: Adding a receiver hitch to the skidder postMike Silviushttp://www.blogger.com/profile/10406468736304441962noreply@blogger.comBlogger4125tag:blogger.com,1999:blog-4229172837911249933.post-38950621296601112052018-07-14T20:14:52.055-04:002018-07-14T20:14:52.055-04:00HA, a thick layer of paint hides all kind of sins....HA, a thick layer of paint hides all kind of sins. ;-) . I was having trouble with my little Clark MIG welder. Could not get it to quit sputtering. Not sure if it is the drive on the wire fed, the shielding gas or simply the mook behind the trigger. Need to figure it out. Had to finish the job with a little Craftsman inverter stick welder. Still not pretty. I did haul one fourteen foot, twenty inch diameter piece with it after this modification, and it did not break, so I guess it is good enough to do the job. But I really want to learn to lay down a roll of dimes like the pros.Mike Silviushttps://www.blogger.com/profile/10406468736304441962noreply@blogger.comtag:blogger.com,1999:blog-4229172837911249933.post-7399102931983277232018-07-14T10:08:17.202-04:002018-07-14T10:08:17.202-04:00I blew the pictures up you did fine on those welds...I blew the pictures up you did fine on those welds :).Gary in Bamahttps://www.blogger.com/profile/00095999376990912465noreply@blogger.comtag:blogger.com,1999:blog-4229172837911249933.post-30920429416781573052018-07-13T14:37:08.204-04:002018-07-13T14:37:08.204-04:00Yea, from about ten feet away. Just don't look...Yea, from about ten feet away. Just don't look at my welds too closely. They are rather frightening.Mike Silviushttps://www.blogger.com/profile/10406468736304441962noreply@blogger.comtag:blogger.com,1999:blog-4229172837911249933.post-73128598105962371802018-07-13T13:52:33.866-04:002018-07-13T13:52:33.866-04:00Good job.Good job.Doughttps://www.blogger.com/profile/07399209326107968220noreply@blogger.com